U-FITAQP: 16) MESSED UP GO-AROUND

Cessna P210-N | N54CC

Santa Teresa, New Mexico

  • DTSB analysis published
Share a tip about this accident

Key facts

  • DateJune 5, 2026
  • Local time11:00 AM
  • LightDay
  • WeatherVMC
  • Phase of flightGo-Around
  • People on board3
  • Fatalities1
  • AirportKDNA

Accident Location

City, State
Santa Teresa, New Mexico
Latitude
31.876019
Longitude
-106.695656
Airport ID
KDNA

Aircraft Info

N Number
N54CC
Make
Cessna
Model
P210-N
Category / Class
Aircraft Single Engine Land
Amateur Built
No

Pilot Info

Pilot in command
MacNeil, Brett Raymond
Gender
Male
Age
55
Certification
Private Pilot
IFR rating
Yes
Medical
3rd Class Medical
Flight school
No
Instructional flight
No

Analysis

Weather
VMC
Time of day
Day
Phase of flight
Go-Around
Pilot error
Yes
Pilot incapacitation
No
People on board
3
Passenger fatalities
1
Total fatalities
1
NTSB travel
Unknown

Probable Cause

THE DTSB

The DTSB determines the Probable Cause of this accident to be pilot error, in that the accident pilot flew a right traffic pattern to runway 28, and ended up too slow with a direct crosswind. A very late go around was initiated after main landing gear touch down, whereupon full throttle was added, and the flaps were retracted. The aircraft was pulled hard to the left in the execution of a messed up go around due to torque and P factor, and impacted 615 feet to the left of the runway centerline, and 1950 feet from the approach end of that runway. The accident aircraft was found with flaps up, gear down, and throttle in the full throttle position. The front right seat passenger died from head injuries received by not wearing the installed and available shoulder harness restraint, a responsibility of the Pilot in Command.

NTSB

None yet (final report not yet published).

Recommendation

THE DTSB

The DTSB recommends that all pilots of all aircraft rehearse and condition themselves to be able to perform late go around maneuvers, where power is added, and pitch angle is reduced to level flight, while flaps are retracted to the takeoff position, then a positive rate of climb is attained, then gear is retracted, then flaps are fully retracted, the aircraft attains DMMS, and then an after takeoff checklist is performed.

Resources